(D) Installation Of The Middle Support Clip (13) - RADEMACHER RolloPort S2 4201 70 71 Betriebsanleitung

(C) Installation of the door bracket (8)
3. Screw the door bracket (8) tight with
the enclosed self-tapping hexagon screws
(8 x 15 mm).
Finally, fix the door connector (12) to the
4.
door bracket (8) with the enclosed bolt (9).
NOTE
A straight door connector is supplied pre-assembled,
and this is permanently fixed to the rail.
If you wish to use the bent door connector (12)
enclosed (depending upon your door particular configu-
ration), you must attach this with two hexagon screws
(8 x 20) to the straight door connector.
5. Finally, secure the bolt (9) by attaching the se-
curing bolt (11) to prevent it from slipping out.

(D) Installation of the middle support clip (13)

1. Fit the middle support (13) clip at a suitable
place, as near as possible to the middle point
between the door and the door operator head.
Key
13 = Middle support clip
14 =
Hexagon screws (8 x 60 mm)
52
13
14
EN
9