Supplied Accessories; Part Names - Onkyo HT-R758 Bedienungsanleitung

5.1ch Home Cinema Package

Supplied Accessories

Make sure you have the following accessories.
Front speakers (SKF-558)
(White)
Front speakers Speaker cables 3.0 m
20 thin rubber stoppers *1 8 thick rubber stoppers
(For Front/Center/
Surround speakers) Surround speakers)
*1 Configuration of the rubber stoppers may be different from the
figure, such as being 2 sheets instead of 1 sheet, but the total
number will be same.
Center speaker (SKC-391C)
Center speaker Speaker cable 3.0 m
HTP-658
E
n
Surround speakers (SKR-558)
Surround speakers
Powered subwoofer (SKW-658)
(Red)
*1
(For Front/
Subwoofer
4 floor pads

Part Names

(Green)
(Blue) (Gray)
Speaker cables 8.0 m
RCA cable 3.0 m
Keyhole slot
Speaker terminals
SKF-558/SKR-558
En-1
Speaker terminals
SKC-391C
Keyhole slots
Caution
• The front grilles are not designed to be removed so do not
attempt to remove them forcibly, as this will damage them.
■
Front
Status indicator
Off: Subwoofer in standby mode or
disconnected from power source
Blue: Subwoofer on
With the Auto Standby function, the
SKW-658 automatically turns on when
an input signal is detected in standby
mode. When there's no input signal for
a while, the SKW-658 automatically
enters standby mode.
SKW-658
■
Rear
OUTPUT LEVEL control
This control is used to adjust the
volume of the subwoofer.
LINE INPUT
This RCA input should be
SKW-658
connected to the subwoofer pre
To AC outlet
out on your AV receiver with
supplied RCA cable.
Note
• The Auto Standby function turns the subwoofer on when the
input signal exceeds a certain level. If the Auto Standby function
does not work reliably, try slightly increasing or decreasing the
subwoofer output level on your receiver.