Herunterladen Inhalt Inhalt Diese Seite drucken

Electrical Interconnection - Crunch DSX4500 Benutzerhandbuch

4-channel class a/b amplifier 2-channel class a/b amplifier
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

I N S T A L L A T I O N I N S T R U C T I O N S
BEFORE THE CONNECTION
For the professional installation of a sound system appropriate wiring kits are available in car audio retailer stores. Attend the sufficient
profile section (at least 10 mm
remove rust-streaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws are
fixed tight after the installation, because loosely connections may cause malfunctions, unsufficient power supply or interferences.
We reccomend therefore the CRUNCH CR10WK wirekit.
GND
1
Connect the GROUND terminal with a suitable contact ground point on the vehicle's chassis. The ground wire must be as short
as possible and must be connected to a blank metallic point at the vehicle's chassis. Ensure that this ground point has a stable
and safe electrical connection to the negative "–"pole of the battery. Check this ground wire from the battery to the ground point
if possible and enforce it, if required. Use a ground wire with a sufficient cross section (at least 10 mm
the plus (+12V) power supply wire.
REM (TURN-ON SIGNAL)
2
Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote signal of your headunit with the REM-terminal of the
amplifier. Use therefor a suitable cable with a sufficient cross section (0,5 mm
with your headunit.
BATT+12V
3
Connect the BATT+12V-terminal with the +12V pole of the vehicle's battery. Use therefor a suitable cable with a sufficient cross
section (min. 10 mm
must be shorter than 30 cm. Do not install the fuse into the fuseblock until the installation is accomplished.
FUSE
4
The inserted fuses protect the amplifier from shorts and capacity overload. The equipped standard fuse is suitable for a 4 ohm
speaker load. For a 2 ohm speaker load the current consumption increases by 50%, thereby the fuses may need to be replaced
by fuses with a higer rating.
REFERENCE NOTE
Installation of RCA/Audio signal cables and power supply.
Observe while installation not to lead the audio cables between the headunit and the amplifier together with
the power supply wires on the same side of the vehicle. The best is a areal separated installation in the
left and right cable channel of the vehicle. Therewith a overlap of interferences on the audio signal will be
avoided. This stands also for the equipped bass-remote wire, which should be installed not together with
the power supply wires, but rather with the audio signal cables.

ELECTRICAL INTERCONNECTION

GND
REM
12V
POWER
INPUT
1
2
3
), the suitable fuse rating and the conductivity of the cables when you purchase your wiring kit. Clean and
2
) and install a additional in-line fuse. For safety reasons the distance between the fuseblock and the battery
2
BRIDGED
FUSE
R
SPEAKER
OUTPUT
4
). Thereby the amplifier will turn on or off automatically
2
2 0
L
) and the same size like
2

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Dsx2350

Inhaltsverzeichnis