Wireless Remote Control; Adjusting The Fog Output Volume - EuroLite DYNAMIC FOG 1500 Bedienungsanleitung

Wireless Remote Control

For wireless remote control operation, disconnect the DMX cable from the unit and configure the function in
the menu.

Adjusting the Fog Output Volume

Fog Output on/off
1
2
Switching the Remote Control on/off
Assigning the Remote Control
www.eurolite.de
Adjust the fog output volume by pressing the MENU button until the graphic depicted
on the left here is being displayed. Then press ENTER to make your settings.
Change the output volume with the buttons ▲ and ▼ from 0 to 5. Once again, press
ENTER to confirm your settings.
Press the left button on the remote control to emit fog. The control LED lights.
To stop the fog output, press the right button.
To set the remote control, press the button MENU until the display indicates "rEno".
Then press ENTER to make your settings. Use the buttons ▲ and ▼ to deactivate
the remote control (indication "off") and to reactivate it (indication "on"). Once again,
press ENTER to confirm your settings.
If the remote control is not working properly when taking the unit into operation, it
must be assigned to the unit. The remote control can be assigned during a short
period of time after switching on the machine as long as the display shows the
indication to the left. To assign the remote control, press and hold one of the buttons
until the display flashes repeatedly, to indicate a match. This can take up to 12
seconds. Thus, the remote control has been assigned to the machine and may be
used for wireless control.
27