Operation Remote Control - Lupine Betty R 7 Bedienungsanleitung

3

Operation Remote control

Connecting the transmitter to the receiver
By default, your lamp has already been connected to the transmitter.

Therefore, you do not have to observe the following steps for a start.
For establishing a connection, the receiving mode in the lamp has to be activated.
Keep the lamp's button depressed until fi ve
button go. The receiving mode is now active for 10 seconds. During this time, press the
remote control's button once to establish the connection between the transmitter and the
receiver. Possible LED signals of the lamp during the 10-seconds period may be ignored.
Several lamps and one transmitter
The pairing principle allows for connecting several lamps with one transmitter. First, activa-
te the receiving mode in the lamps, then press the transmitter's button within 10 seconds.
Transmitter and receivers are secured by a code so that the lamps may not be operated by
an unknown transmitter.
Several transmitters and one lamp
Up to 3 transmitters may be connected to one lamp. The transmitter-specifi c codes are
stored in the lamp according to a "fi rst in fi rst out" principle. If you want to use only one
transmitter again to control your lamp, it might be necessary to connect this transmitter
up to 3 times with the lamp until all other codes in the list will have been overwritten.
38 Betty R
green LEDs light up and let the
Transmitter LED backlight
By default, the blue LED of the transmitter lights up for 20
minutes each time the button has been pressed. Keep the but-
ton depressed for 10 seconds to deactivate the backlight. For
reactivation, keep the button depressed again for 10 seconds
and then release.
Note: With sinking battery voltage, the blue backlight will fade
out until it disappears. Also cold temperature will reduce the
battery voltage.
Transmitter battery warning
With a fully charged button cell, the transmitter's LED will be
bright blue. With decreasing voltage, the LED will also become
weaker. If the voltage of the button cell decreases further, both
the blue and the red LED will light. Finally, only the red LED of
the button will light up but also fade out with sinking voltage.
In practice, you may keep on using the transmitter for some
time even after the red LED stopped working, however chan-
ging the battery is recommended.
Transmitter battery change
For changing the battery, loosen all 4 screws at the bottom
of the transmitter using a T5 torx screw driver. Insert the new
CR 2016 button cell as shown and close the transmitter again.
Tighten the screws until the blue sealing is visibly squeezed.
3
Betty R 39