Herunterladen Inhalt Inhalt Diese Seite drucken

Setting Up And Connecting; Unpacking; Starting Up; Remote Control Battery Installation - Clatronic CTV 732 Bedienungsanleitung

Lcd-fernseher/dvd-player mit dvb-t-receiver
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Unpacking

Setting up
Remote control
battery installation
44
05_CTV732_GB 44

Setting up and connecting

Unpack the appliance and all accessories and check that the contents are
complete.
ATTENTION:
Always transport/send the player in its original packaging to prevent it from
being damaged. Keep the packaging for this purpose. Dispose of unneces-
sary packaging material in accordance with the regulations applicable in your
country.
NOTE:
Get in touch with your dealer immediately if you notice damage caused by
transport.
1. Place the player on a stable, heat resistant, horizontal and level surface. Keep
a distance of at least 10 cm from walls and objects.
2. Connect the device to a properly installed power socket.

Starting up

WARNING:
Leaking out battery acid can damage your health. Remove the battery from the
battery compartment as soon as it is exhausted or if the remote control is not
going to be used for a longer period of time. Wipe up leaked out battery acid
with a cloth. In case of skin contact immediately wash the affected area. Seek
medical advice if battery acid has been swallowed.In case of contact with your
eyes wash out the eyes and seek medical advice.
ATTENTION:
Mismatching battery types or new and used batteries must never be used
together. Different battery types have different properties. Do not use old and
new batteries together. The mutual use of old and new batteries can shorten the
lifetime of the new batteries and possibly result in leakage of the old batteries.
When disposing of old batteries you should strictly comply with the legal and
environmental regulations applicable in your country. Do not throw batteries
into fi re!
NOTE:
The lifetime of the enclosed batteries may be shortened because of storage.
1. Open and remove the battery compartment cover.
2. Insert two batteries of type AAA/R03 (1.5 V), ensure correct polarity
(+ and -). Start with the negative pole (-).
3. Attach and close the battery compartment cover.
NOTE:
The signals from the remote control are transmitted to the DVD-Player by infra-
red light. You should therefore take care that the DVD-Player is not exposed to
the direct sunlight. This could make the transmission of signals from the remote
control to the DVD-Player impossible.
16.05.2007, 15:05:54 Uhr

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis