Remove Transport Lock; Operation - Kärcher FP 303 Handbuch

Remove transport lock

Illustration
 Remove the transport locks the first
time you use and before using the appli-
ance by pulling them off.
Assemble the strut and attach it
Illustration
 Assemble both parts of the strut and se-
cure with the enclosed screw and nut.
 Insert the entire strut into the polishing
head and attach with a screw.
Note: Here, take into account the loca-
tion of the mains cable.
Illustration
 Press the mains cable into the attach-
ments and tension it.
Connect suction hose
Illustration
 Insert the straight end of the suction
hose into the polishing head, insert the
bent end into the strut connection.
Inserting the cloth bag
Illustration
 First, push the upper part of the cloth
bag into the intake until it locks.
 Then attach the bottom part to the strut
using the Velcro pad.
Inserting a filter bag
Illustration
 Open the zipper of the cloth bag.
 Insert the filter bag and slide the carton
with the opening over the support until it
locks into place. Recheck the correct
positioning of the filter bag.
 Close the zipper on the cloth bag.
Insert pad holder
Illustration
 Place the appliance on the floor so that
the polishing head is positioned perpen-
dicular to the surface.
 Simply press the pad holder into the in-
take. Ensure that the noses of the pad
holders lock well into the intake.
 To remove the pad holders, simply pull
them off.
Insert the polishing pads
Illustration
 Install the polishing pads on the pad
holders and ensure that they are cen-
tered properly.
 To remove the polishing pads, simply
pull them off.
Storing the polishing pads
 The polishing pads can be stored in a
separate compartment in the bottom
part of the cloth bag.
Note:
Always work with the filter bag inserted.
Caution
Before inserting the mains plug, ensure
that the strut is located in a vertical position.
The appliance is switched off in this posi-
tion.
Illustration
 Turn the upper cable hook and remove
the mains cable. Insert the mains plug
into a socket.
Illustration
 Press hold down the unlocking key. Pull
the shaft in the rear direction. The de-
vice is activated.
 To stop the appliance, bring the strut
back to the vertical position until it locks.
– 5
EN

Operation

11