Siemens TE657F serie Bedienungsanleitung Seite 43

F
Touching I displays each setting
or selection option in order. After
you reach the lowest menu item the
topmost one is shown again.
For example:
Setting the coffee temperature to max. :
■ Touch A. The menu is opened.
■ Touch I repeatedly until the display
shows Coffee temperature.
■ Touch B, the display shows e.g. high.
■ Touch I repeatedly until the display
shows max.
■ Touch B to store the setting. The
display shows the confirmation.
■ The menu item Coffee temperature
appears.
■ Touch F to exit from the menu.
You can specify the following settings:
Cleaning and care
Starting the special service programmes.
You can select Rinse the milk system,
Descale, Clean or calc'nClean.
■ Use I to choose the desired
programme and touch B to confirm
your choice.
■ Touch C to begin running
the programme.
F
Important: Be sure to take note of
the section on "Service programmes".
Info Service programmes
(depending on the type of appliance)
Display how many beverages can still be
prepared before it will be necessary to run
one of the service programmes.
■ Use I to display Clean after --- c or
Descale after --- c.
■ Touch F to exit from the display.
F
For technical reasons the counter
does not represent a precise number
of cups.
Coffee-milk ratio
The coffee-milk mixing ratio set in the
factory can be adjusted in several steps.
■ Use I to select the beverage (only
for coffee drinks with milk) and confirm
with B.
■ Use I to select the desired mixing
ratio (setting of milk content in %) and
confirm with B.
■ The setting is saved.
Example: If a value of 30% is selected,
30% milk and 70% coffee will be dispensed.
Favourite
The menu item Favourite can be used to
create or change personalised beverages.
The number of Favourites depends on the
model of the appliance.
■ Use I to select a new or existing
profile and confirm with B
■ Touch the desired beverage and confirm
with B.
■ Your selection for the beverage settings
appears on the display depending on the
beverage, e.g. ml or Coffee-milk ratio.
■ Make your settings and confirm with
B each time.
■ The beverage is now saved in the profile.
Set cup size
Set up the volume dispensed for each drink
and each size of cup. The volumes set up in
the factory can be adjusted stepwise.
■ Use I to choose a drink and touch
B to confirm your choice.
■ Use I to choose the desired volume
and touch B to confirm your choice.
The setting is then saved.
Water hardness
Set this to the hardness of the local water
supply.
Level 1, 2, 3, 4 or Softening system can be
selected. The preset level of water hard-
ness is level 4.
■ Use I to choose the desired water
hardness and touch B to confirm
your choice.
Menu en
39