Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
you have made.
The function light above the button lights up and a short
acoustic signal will sound when the charging of the condenser
has finished. You can now start flashing. If the function light is
turned off, you are not able to flash.
5. Overheating protection
If an thermal overload of the device occurs (fast flash sequences
with high flash energy and activated modeling lamp over a
long time; high environmental temperature), the overheating
protection will be activated and the flash condenser can not be
charged. This is a normal protective function that protect the
device from serious damage.
• Let the device cool down.
• Switch off the modeling lamp.
• Do not power off the device during the cooling process.
Otherwise the internal fan is not working.
Once the internal temperature is on a normal level again,
condenser is charged to the selected flash energy, the light
above the Test button will light up and a short acoustic signal
will sound. The device is now ready for use.
6. Operating the flash with a remote control (Optional
accessory)
1. Put the receiver's 6.35mm plug (see 'Optional accessories')
into the 6.35mm slot (Fig. 2, H) of the studio flash.
2. Follow the instructions of the remote control to get a coded
connection between the remote control and the receiver.
The studio flash and the remote control are then successfully
connected.
Optional accessories
Wireless remote control T-12
Art. No. F001143
- Receiver with 3.5mm or 6.35mm plug (included 6.35mm adapter)
- Synchronous triggering of several flashes
- 8 channels
- Shortest shutter synchronization: 1/200 sec.
- Suitable for camera hot shoe/center contact (except Minolta
Dynax and Sony Alpha)
Much more accessories such as light modifiers, tripods and bags
available in our webshop at www.photostudio-equipment.com
Cleaning and maintenance
Before cleaning the device, disconnect it from the power
supply (remove plug)!
Only use a dry cloth to clean the exterior of the device. To avoid
damaging the electronics, do not use any cleaning fluid.
Protect the device from dust and moisture. Store it in the
supplied bag or transportation packaging. The batteries should
be removed from the unit if it has not been used for a long time.
Disposal
Dispose of the packaging materials properly, according to
their type, such as paper or cardboard. Contact your local
waste-disposal service or environmental authority for information
on the proper disposal.
Do not dispose of electronic devices in the household
garbage!
As per Directive 2002/96/EC of the European Parliament on
waste electrical and electronic equipment and its adaptation
into German law, used electronic devices must be collected
separately and recycled in an environmentally friendly manner.
Please take the current legal regulations into account when
disposing of your device. You can get more information on
the proper disposal from your local waste-disposal service or
environmental authority.
EC Declaration of conformity
Bresser GmbH has issued a "Declaration of Conformity"
in
accordance
with
corresponding standards. This can be viewed any time upon
request.
applicable
guidelines
and
DE
GB
9
Werbung
Inhaltsverzeichnis
