JVC TK-C1460 Bedienungsanleitung Seite 28

MENU SETTING
ALC SETTINGS Screen (Continued)
Item
FAST LIMIT
ExDR
LEVEL
M.ExDR
SPEED
AGC MODE
SENSE UP
E-28
Functions and set values
This sets the fastest value of a shutter speed when AUTO is set.
The MANUAL, M. ExDR, A. ExDR set value is displayed as "- - -" and
cannot be changed. The higher the shutter speed becomes, the more
smear phenomenon is emphasized, which is peculiar to the CCD.
[Set values: 1/1000, 1/2000, 1/4000, 1/10000, 1/20000, 1/40000, 1/100000]
This sets the signal level of the composing high-speed shutter during
ExDR mode. This is set according to the brightness of a subject.
When using M.ExDR, be sure to set M.ExDR SPEED in advance.
When the SHUTTER (ExDR) item is set to MANUAL or AUTO,
"- - -" appears, disabling setting.
To give priority to the low-brightness par ts of the subject...
increase the value
To give priority to the high-brightness parts of the subject...
decrease the value
[Set values: –5 to NORMAL to 5]
MEMO
• In the case of a subject with a large difference in the luminous
flux density, sometimes images do not change even if ExDR
LEVEL is varied. However, this occurrence is a peculiarity of
the unit and is not a malfunction.
This sets the composing high shutter speed when ExDR is set to M.ExDR.
Set the shutter speed in order that a subject with a high luminous flux
density (outdoor, etc.) may come out most clearly. This is displayed as
"- - -" during MANUAL, AUTO or A. ExDR and cannot be set.
[Set values: 1/500, 1/1000, 1/2000, 1/4000, 1/10000, 1/20000]
This sets a maximum gain of the AGC (Automatic Gain Control).
OFF: When the AGC function is not used.
10dB: When luminous energy is insufficient.
20dB: When luminous energy is extremely insufficient.
SUPER: When brightness is insufficient even when it is set to
20dB.
• If the gain is increased, the screen gets rough in a dark place.
• If it is set to SUPER, it can sometimes consume operation time
to cope with a drastic level change.
• When the item "B&W" is set to "AUTO", [SUPER] is displayed when
the item "AGC MODE" is set to "SUPER", and [20dB] is displayed
for other settings. Increase the gain up to the value displayed.
This item makes up a sensitivity should be heightened automatical-
ly when a subject becomes dark.
In case of the X32 AUTO, the sensitivity is automatically heightened
up to 32 times continuously as compared with standard.
As the sensitivity becomes higher, the shutter speed becomes
lower, resulting in unnatural motion.
If SHUTTER (ExDR) is set to MANUAL or the M.ExDR,
"- - -" will appear, disabling the SENSE UP function.
[Set values: OFF, X2 AUTO, X4 AUTO, X8 AUTO, X16 AUTO, X24
AUTO, X32 AUTO]
MEMO
• When the magnification of SENSE UP is enhanced, the screen
can become coarse or whitish, or whitish flaws can emerge
sometimes, but this is not abnormal.
• When the item SENSE UP is set other than to OFF, a flicker can
occur under a fluorescent lamp, mercury lamp, etc. However,
this occurs by principle of SENSE UP, and therefore this is not a
malfunction.
Initial value
1/100000
NORMAL
1/4000
20dB
OFF