JVC TK-C1460 Bedienungsanleitung Seite 11

[DC 12V, AC 24V] Power input terminals
19
To input DC 12V or AC 24V power.
[TX+A, TX-B, RX+C, RX-D] Control
20
signal connection terminals
Terminals for inputting signals with
electrical characteristics conforming to
the EIA/TIA RS-422A or RS-485 standard.
( Page 10
17
[AUX, GND] Auxiliary Input/Output
21
Terminals
If there is any change in the area set on
the MOTION DETECT screen, these
terminals output the corresponding
signals. ( Page 34)
These terminals also output the B&W/
COLOUR signal. (
[Open-collector low signal. Maximum
voltage 30V, current 30mA.]
When carrying out B&W/COLOUR
switching using the control signal, the
signals are input through these terminals.
( Page 30)
[B&W: make; COLOUR: break]
[Y/C OUT] Y/C output connector
22
This 4-pin connector outputs the luminance
and chrominance signal.
• Pin configuration of Y/C OUT connector
(
+
1
fi
SYNC IN
›
POWER
‹
RX.TERM switch)
Page 30)
)
-
2
+ - + -
AUX GND
TX TX RX RX
A B C D
Y/C OUT
VIDEO OUT
SEE INST-
RUCTION
MANUAL
4
2
Pin No.
1
2
3
4
[VIDEO OUT] Video signal output
23
connector
This BNC connector outputs a composite
video signal. Connect this to the video input
connector of a video monitor, switcher, etc.
[POWER] Power indicator lamp
24
This lamp lights when power is supplied
to the camera.
[SYNC IN] Sync signal input connector
25
This BNC connector accepts the input of
an external sync signal such as a composite
video (VBS) or black burst (BB) signal.
When a sync signal is input into this
connector, the camera operation is
automatically synchronized with the
external sync signal.
To terminate this connector at 75Ω, turn
ON the EXT.TERM switch
⁄
¤
3
1
Signal
GND
GND
Luminance (Y)
Chrominance (C)
.
14
E-11