Corrective Action - Bosch AKE 30 LI Originalbetriebsanleitung

OBJ_BUCH-1275-004.book Page 34 Monday, April 4, 2016 1:04 PM
34 | English
Troubleshooting
The following chart lists problem symptoms, possible causes and corrective action, if your power tool does not operate properly.
If these do not identify and correct the problem, contact your service agent.
 Warning: Switch off and remove the battery prior to any troubleshooting.
Problem Possible Cause
Chain saw fails to Kickback brake is activated
operate
(a warning sound ("beep") can be heard)
Battery discharged
Battery not fully connected
Motor protector has activated
Battery too hot/cold
Saw chain will not Battery discharged
move
Power tool defective
Chain saw operates External or internal wiring defect
intermittently
On/Off switch 3 defective
Saw chain dry No oil in reservoir
Vent in oil filler cap 4 clogged
Oil passage clogged
Brake does not stop Kickback brake defective
saw chain
Saw chain/guide bar No oil in reservoir
hot
Vent in oil filler cap 4 clogged
Oil passage clogged
Chain tension too high
Dull saw chain
Chain saw rips, Chain tension too loose
vibrates, does not
Dull saw chain
saw properly
Chain worn out
Chain teeth are facing in the wrong direction
Excessive vibra- Power tool defective
tions/noise
Sawing time per bat- Too much friction, due to lack of lubricant
tery charge too low
Saw chain needs cleaning
Poor sawing technique
Battery not fully charged
The saw chain is run- Battery discharged
ning slow
Battery stored outside of battery temperature
F 016 L81 531 | (4.4.16)

Corrective Action

Pull activation lever for kickback brake (hand
guard) 6 back in position 
Recharge battery; also see "Battery Charging"
Ensure both locking levels are engaged
Allow motor to cool
Allow to cool/warm
Recharge battery; also see "Battery Charging"
Contact Service Agent
Contact your Bosch Service Centre
Contact your Bosch Service Centre
Refill oil
Clean oil filler cap 4
Clean oil passage
Contact your Bosch Service Centre
Refill oil
Clean oil filler cap 4
Clean oil passage
Tension saw chain
Sharpen saw chain or replace
Tension saw chain
Sharpen saw chain or replace
Replace saw chain
Reassemble with chain in correct direction
Contact Service Agent
Ensure that lubrication is working (see "Saw-chain
Lubrication")
Clean saw chain
see "Working with the Chain Saw"
Recharge battery; also see "Battery Charging"
Recharge battery; also see "Battery Charging"
Allow battery to warm naturally to room tempera-
ture (within battery operating temperature
0 – 45 °C)
Bosch Power Tools