Pioneer FS-W40 Bedienungsanleitung Seite 18

> Before Start > Part Names
Source
■ Input Volume Absorber
Adjust the volume level difference between the devices connected to the unit. Select the
input selector to configure.
Input Volume Absorber Select a value between "
value if the volume of the target device is larger than the others
and a positive value if smaller. To check the audio, start playback
of the connected device. (Default Value is 0 dB)
■ Fixed PCM
Fixed PCM Select whether to fix digital audio input signals to PCM (except
multi-channel PCM). Set this item to "On" if noise is produced or
truncation occurs at the beginning of a track when playing PCM
sources. Select "Off" normally. (Default Value is Off)
0 The setting cannot be changed when "NET", "
input is selected.
> Install > Setup
12 dB" and " 12 dB". Set a negative
– +
", "USB", "TUNER", or "ANALOG IN"
> Playback
Supplementary information | Firmware Update | Others
Hardware
■ HDMI
HDMI CEC Setting to "On" enables the input selection link and other link
functions with HDMI connected CEC compliant device.
"On": Use this function
"Off (Default Value)": Do not use this function
When changing this setting, turn off and then on again the power
of all connected components.
0 Depending on the TV set, a link may need to be configured on
the TV.
0 Setting to "On" and closing the on-screen menu displays the
name of the CEC-compatible components and "CEC On" on
the display of the sound system controller.
0 Power consumption in standby mode may increase if "On" is
set. (Depending on the TV status, the unit will enter the
normal standby mode.)
0 If you operate the VOLUME buttons on the unit when this
setting is "On" and audio is output from the TV speakers,
audio will be output also from the speakers connected to the
unit. If you want to output from only either of them, change the
unit or TV settings, or reduce the volume of the unit.
0 If abnormal operation occurs when you set the setting to "On",
set it to "Off".
0 When connecting a non-CEC compatible component, or when
you are not sure whether it is compatible, set the setting to
"Off".
E
N
17