Changing The Saw Blade; Setting Tape / Camber - Holzmann BS 128HDR Originalbetriebsanleitung

14.1 Changing the saw blade

Move the metal belt in the vertical position and open the saw band cover.

Loosen the saw band with the adjustment knob (10).

Saw band guard above remove.

Now pull off the old

DANGER! Risk of
The new bandsaw first insert in the blade guides and then

place it on the wheels.
WARNING: Respect the right direction of the
image left front of the saw
Then put the saw band on the wheels.
The saw band with the control knob (2) tension (2 - 3mm

test).
After a short test run check the tension and the tape /

chamber and tighten, it neccesary as in point 14.2
Saw blade guard screw on.

Close the saw band cover.


14.2 Setting tape / camber

The impeller is factory aligned to the drive wheel. Should, however (especially after exchange) of
the saw blade is not straight or run from the impeller, an adjustment may be necessary.
The tape / camber can be adjusted.
The clamping screw slightly loose.

With the grub screw the tape can be adjusted.

Tighten the clamping screw.

HOLZMANN Maschinen Austria
saw band of the impellers.
injury! Wear work gloves.
arm)
clamping screw
www.holzmann-maschinen.at
MAINTENANCE AND CARE
teeth. (see
Saw band guard
grub screw
Seite 38
BS 128HDR