Operational Start-Up; Fitting The Hoses; Operation - ULTIMATE SPEED UOP 12 B1 Originalbetriebsanleitung

Operational

Fitting the hoses

1. Remove the protective caps (
2. Unroll the suction hose (9) and the
drain hose (11) and bend them
straight.
3. Push the suction hose (ø 6 mm)
(9) onto the suction hose connec-
tion (8).
4. Slide the drain hose (ø 12 mm)
(11) onto the drain hose connec-
tion (6).
5. Attach both hoses (9, 11) with the sup-
plied hose clamps (10).
Note the pumping direction
Ensure that the hoses (9, 11) are
not bent or kinked to avoid dam-
age.

Operation

Let the vehicle engine run for
5-10 minutes before pumping in
order to warm up (oil temperature
max. 60 ° C). This reduces the vis-
cosity of the oil and it can pump out
better.
Turn off the car engine before you
start pumping.
1. In the case of vehicles, feed the suction
hose (ø 6 mm) (9) through the oil level
test aperture. Gently slide the hose to
the lowest point of the oil pan.
2. Insert the drain hose (ø 12 mm) (11)
into a suitable container (e. g. oil col-
lecting tray) to collect the used oil.
start-up
7).
IN
OUT
of the appliance.
3. Make sure that the appliance is
switched off (on/off switch (1) in posi-
tion "O").
4. Connect the positive pole terminal (red)
(4) to the positive pole (+) of the vehi-
cle battery.
5. Connect the negative pole terminal
(black) (5) to the negative pole (-) of
the vehicle battery.
6. Switching on:
On/off switch (1) in position "I".
After a suction period the pump begins
to extract.
7. Switching off:
On/off switch (1) in position "O".
Turn the power off
- as soon as the oil ceases to be ex-
tracted,
- or after a continuous running time of
30 minutes.
8. Clean the appliance after each use by
pumping through some fresh oil.
9. Remove the terminals (4, 5) from the
vehicle battery.
Never pump for longer than
30 minutes in continuous operation
in order to prevent overheating and
damage to the appliance. Turn off
the appliance and allow it to cool
for at least 10 minutes between the
run cycles.
Change the oil filter and replenish
with fresh oil according to the in-
structions of your vehicle manufac-
turer.
Dispose of used oil in an envi-
ronmentally-responsible way (see
"Waste Disposal/Environmental
Protection").
GB
9