Rejecting A Call Waiting; Call Forwarding (Cf); Malicious Call Identification (Mcid); Phonebook - Topcom butler 5070 Bedienungsanleitung

Butler 5070
If you want to end the first call before accepting the second press the LINE button.
The handset will ring.
Press the LINE button again to accept the call.

5.7.2. Rejecting a Call Waiting

When you hear the knocking tone and you want to reject the call , press OPT.
Select REJ. with the UP- and Down key.
Press OK to confirm
5.8.

Call Forwarding (CF)

You can forward a specified MSN number to another telephone number (ex. Mobile Phone).
This forwarding can be activated/deactivated always (UNCONDITIONAL), when the MSN number is
busy (ON BUSY) or when there is no answer (NO REPLY).
!!! The No Reply time depends on the telephone provider.
- Press MENU when the unit is in standby mode..
- Select ISDN SETTING by using the UP- and DOWN keys.
- Press OK to confirm.
- Select CALL FORWARD by using the UP- and DOWN keys.
- Press OK to confirm.
- Select the MSN, you want to forward by using the UP- and DOWN keys.
- Press OK to confirm.
- Select if want to activate SWITCH ON, deactivate SWITCH OFF the forwarding.
- Press OK to confirm.
- Select the Call Forwarding condition by means of the UP- and DOWN keys.
- If you want to activate the call forwarding, the telephone number, towards you want to forward the
call, must be entered.
- Press OK to confirm
- The display shows <SUCCESS>
5.9.

Malicious call identification (MCID)

To identify a non transmitted caller number you can activate MCID function if supported by the ISDN
network.
- On incoming call press line key to answer the call and select MCID
The calling number will now be registered in the ISDN network. Contact your ISDN supplier to get
access to the number.

6. PHONEBOOK

6.1.

Use of the alphanumerical keypad.

Use the alphanumerical keypad to enter text. To select a letter, press the corresponding button. For ex.,
if you press numerical button '5', the first character (J) will be shown on the display. Press multiple
times if you want to select another character under this button.
Press button '2' twice to select the letter 'B'. If you want to select 'A' as well as 'B', press button 'A'
first, wait for 2 seconds until the cursor has moved to the next location and select then button 'B'.
Wrongly entered characters can be erased by pressing the C button. You can move the cursor by means
of the UP and DOWN buttons. The character in front of the cursor will be erased.
76