Adjustment Of Volume; Setting Of Operating Mode - TIPTEL 204 Bedienungsanleitung

Adjustment of volume

When the device is switched on, the electronic volume control is set to a medium
level (level 3).
By means of the keys
rected during the playback of messages and notes.
The new setting for volume will be saved.
If the volume is set during the stand-by operation, a short signal tone in the corres-
ponding volume can be heard during each setting process.
If the volume is increased, a steadily ascending signal tone will be emitted. If the vol-
ume is reduced, a steadily decreasing signal tone can be heard. The highest and
lowest possible volume setting is indicated by two short signal tones (maximum vol-
ume for maximum setting, medium volume for minimum setting).
The volume setting can be carried out as follows: either
keep the volume + or volume – key pressed or
1.
press the volume + or volume – key several times.
2.
The keys volume +/- are also active during the waiting time of 8 seconds at the end
of the message playback. However, no signal tones will be emitted during the volume
adjustment.

Setting of operating mode

The answering machine offers three different operating modes which can easily be
selected (refer to table under 3.2.):
•
answering mode
•
announcement-only mode
•
answering machine off.
It is possible to switch between these modes as often as you like without deleting,
modifying or destroying a set OGM/ICM or note.
In the answering mode, you can program after how many ringing signals the answer-
ing machine shall pick up or in case you want to use the remote control function –
you can set the device to the charge saving function. If the answering machine picks
up the call, it provides the caller with your pre-recorded information and asks him, for
example, to leave a message for you. Now, the caller may record a message with a
maximum length of 2 minutes. Afterwards, the answering machines switches off
Settings
1 3
– and +, the requested volume can be set or be cor-
70