Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Try plugging all devices into the same socket via an AC power
distributor/power strip. If this doesn't eliminate the noise, you
must ensure the connection is galvanically separated by routing
the signal through a DI box.
6.5 You have connected an FX processor to the LINE
OUT jack and the signal is totally distorted,
even when you have dialed in a clean sound.
- The LINE OUT signal is overloading the input of the FX
processor. Reduce the processor's input sensitivity ("INPUT" or
"GAIN").
6.6 You have connected an FX processor to the LINE
OUT jack of the CLUB REVERB and the signal's
volume level is way too low.
- The FX processor's output level is set incorrectly. Turn it up.

7.0 TECHNICAL DATA

Preamp Section
Preamp section:
CLEAN + LEAD solid state channels
INPUT:
-10 dBV/ 1 M ohm
LINE OUT:
0 dBV/ 1k ohm
LINE IN:
0 dBV/ 47 k ohms
Power amp section::
'CURRENT FEEDBACK' solid state power amp
Output Power: 65 watts rms into 8 ohms
Freqency response: 20 Hz - 30 kHz (into 8 ohms)
Speaker:
CELESTION RockDriver Junior, 12", 8 ohms
General features:
Voltage:
230 V~ (European model)
117 V~ (North American model)
100 V~ (Japanese model)
Max. power consumption: 175 VA
Mains Fuse:
slo-blo 500 mA (230 V model)
slo-blo 1000 mA (117 V model)
slo-blo 1250 mA (100 V model)
Dimensions: (W x H x D)
Weight:
approx. 33 lbs./approx.15 kgs.
464 x 480 x 265 mms
18" x 18.9" x 10.4"

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis