Remote Transmitter / Remote On/Off Receiver - VOLTCRAFT COST CONTROL 3000 SET 2011 Bedienungsanleitung

5.

REMOTE TRANSMITTER / REMOTE ON/OFF RECEIVER

The Transmitter is designed to control our Indoor Appliance Receiver. You can use this Transmitter to control the Receivers for any
plug-in electrical appliances.
The Transmitter has 4 channels, which can control up to 4 receivers.
Intelligent Code setting and Learning function means there is no complicated setting of code switches and interference by other
remote control system is nearly impossible.
Button configurations
Transmitter:
ON
OFF
BRIGHT
DIM
ALL ON
ALL OFF
RESET
(located inside the battery compartment)
Receiver:
LEARN Learn the System Code and Channel number assigned by the Transmitter
ON/OFF Turn on/off the plugged-in devices manually
Setting Up the Remote Transmitter
1. Open the battery cover at the back of the Transmitter.
2. Install one 9V battery (included) into the battery compartment while observing the correct polarity.
3. Using a small pointed object, press the RESET button once to generate a unique System code so that this set of remote control
will not be interfered by other similar systems nearby. The RESET button is located in the top left hand corner of the battery
compartment.
4. Put the battery cover back onto the Transmitter.
5. Press one of the ON / OFF buttons to check if the transmitter works; if yes, the indicator light will light.
Setting up the Receiver
1. Plug the receiver in an earthed mains socket and switch it on with the ON button. The indicator light will illuminate.
2. Aim the transmitter at the receiver from a distance of about 50 cm.
3. Press the ON button (1, 2, 3 or 4 ON) for the appropriate channel and the receiver's LEARN button at the same time for a few
seconds. The self-learning function will now undertake the coding from over 4,000 possible codes. You can now switch the
connected appliances on or off by remote control.
4. Repeat this procedure again with the other receivers.
5. You can control several receivers at the same time using one transmission button (channel).
6. In this case synchronise each receiver with the transmitter channel.
7. The transmitter code is preserved when the battery is replaced.
8. If you disconnect the receiver from the mains, the transmitter and receiver codings are preserved for about 5 minutes. Reconnect
the receiver to the mains supply within this period. If you do not, then the transmitter and receiver must be re-synchronised.
9. Press the reset/recode button to randomly select a new house code from the 4,000 possible codes available. All the receivers
must then be resynchronised.
Only press this button when you think that the set-up of the remote control is being impaired by other signals.
10. Avoid interference: please ensure that the distance between the various receivers is approx. 50 cm.
11. Every receiver has an additional manual ON / OFF switch. You can also switch the receiver on or off without the remote control.
The indicator light indicates whether the receiver is in ON / OFF mode.
The 4 ON buttons will turn on the receiver of the respective channel
The 4 OFF button will turn off the receiver of the respective channel
Increase the brightness of the plugged-in lamps (applies only to the wireless socket
with dimming function, identifiable by the label "Dimmer")
Decrease the brightness of the plugged-in lamps (applies only to the wireless socket
with dimming function, identifiable by the label "Dimmer")
Turn on ALL the receivers at the same time.
Turn off ALL the receivers at the same time.
Generate a new System code
19