Working Advice - Bosch GHE Professional 60 T Betriebsanleitung

OBJ_BUCH-2419-003.book Page 14 Thursday, February 11, 2016 9:51 AM
14 | English

Working Advice

When cutting hedges always start with the sides first, working
from the bottom upwards in a radial movement followed by
the top. If hedge is deep ensure cutting is carried out in stag-
es.
Never attempt to remove material from the blades while the
battery is inserted and do not hold material to be cut. Switch
off and remove the battery from the machine whenever clear-
ing jammed material. Failure to do so may result in serious
personal injury.
For optimum performance
Blade Type Cutting length
roughing 600 mm
roughing 700 mm
trimming 600 mm
Troubleshooting
d.c.
Problem Possible Cause
Machine fails to operate Battery discharged
Battery too hot/cold
Rear handle not fully located
Trigger engaged when battery fitted
Cutting blade obstructed
Low battery capacity
Battery not fully inserted
Machine runs intermit- On/Off switch defective
tently
Low battery capacity
Battery not fully charged
Bale bar and/or trigger not fully engaged
Poor cutting performance Cutting blade damaged/blunt
F 016 L81 090 | (11.2.16)
Take extra care when cutting above shoulder height.
Caution! Base plate may become hot during operation.
Wait until the blades have come to a standstill before placing
down the hedge trimmer.
Your machine is fitted with an electronic device, which will
minimise the risk of the blade jamming in heavy cutting condi-
tions. This will allow easy removal of the machine from the
hedge. Restart the machine by the on/off switch.
Application
The garden tool is designed for cutting hedges with thicker stems and
branches up to 25 mm diameter such as the following:
– Hardwood hedges: Blackthorn, Hawthorn, Berberis
– Softwood hedges: Lleylandii, Cotoneaster, Buxus
The garden tool is designed for shaping and trimming hedges with thinner
stems up to 10 mm diameter such as the following:
– Hardwood hedges: Blackthorn, Hawthorn, Berberis
– Softwood hedges: Lleylandii, Cotoneaster, Buxus
– Deciduous shrubs: Japanese Maple, Hydrangea, Spirea
– Evergreen shrubs: Azaleas, Rhododendrons, Hollies, Laurels
Corrective Action
Recharge battery
Allow to cool/warm
Check handle is positioned in 0° or 90°
Release trigger and reapply.
Switch off the machine, remove battery and re-
move material
Ensure battery is fully charged before use
Ensure battery is inserted correctly
Have the power tool repaired by an approved
dealer
Ensure battery is fully charged before use
Check battery display – charge battery if nec-
essary
Engage both triggers fully
Carry out blade resharpening by a Bosch ap-
proved dealer
Bosch Power Tools