Basic Settings - Medion MD 24019 Bedienungsanleitung

Basic Settings

After switching on the receiver for the first time or after using the Factory Reset function
you will be asked to choose your OSD language and your geographical location. Afterwards
you should perform the following steps:
1. Open the main menu.
2. Go to "Edit Settings"
3. Enter the "Satellite Systems" menu. Mark the satellite that you
want to receive by pressing the OK key. The activated satellites will
be marked with a Plus sign.
Leave the satellite list by pressing EXIT.
4. If you only receive the signals from one satellite please continue to
point 7 of these instructions.
If your satellite system allows you to receive more than one satellite
you can activate the integrated DiSEqC 1.0-switching system. Enter
the "Reception" menu to set up this feature.
5. Choose the heading "Equipment Control" and select "DiSEqC easy"
using the arrow keys.
6. Choose up to four satellites that are connected to the inputs of your
switch in the "Satellite A –D" lines. If f.e. you receive only Astra 1
(19.2°E) and Hotbird (13.0°E), you would usually enter "Astra 1"
as Satellite A and "Hotbird" as Satellite B.
Only satellites that have been activated in step 3 are available.
You can either use the left/right to select the satellites. If you press
OK the list of all activated satellites is displayed to simplify the se-
lection.
7. Go to "Signal Output". Select the screen format for your TV.
8. If you wish to control the volume through your receiver go to point 9
of these instructions.
Reduce the volume of your TV and amplifier (Hi-Fi) to its minimum
before carrying out the following steps.
If you wish to control volume from the connected device (amplifier,
TV, etc.) go to the heading "Volume-bypass" and choose the out-
puts for the source of the full volume level.
9. Leave the "Signal Output" menu by pressing EXIT and move to the
heading "Save Settings". Press OK and wait until the menu disap-
pears.
60
Press MENU
button
twice
– / +
– / +
OK
– / +
– / +
OK
MD 24019