Flash Bracketing Series (Fb) - Metz MECABLITZ 58 AF-2 Pentax Bedienungsanleitung

Beep signals when adjusting automatic mode settings:
• A short beep signal as an alarm in automatic mode indicates that the apertu-
re and ISO settings exceed the permissible light control range. The auto aper-
ture of the mecablitz is then automatically adjusted to the next permissible
value.
Setting procedure:
Select
• Press the
Beep
appears on the display.
Remote
Set
• Use the
the menu. The selected menu item will be highlighted
against a dark background.
• Press the
ON
tion selection.
• Choose the setting desired using the
Set
arrows. The setting takes effect immediately.
• Press
mal reading. If the key
will switch back to normal automatically after
approximately 5 seconds.
P TTL F 4.0
MZoom 24
10 m ISO 200
button repeatedly until „Select"
Sel
and buttons to select „BEEP" from
button to confirm the special func-
Set
and
repeatedly to return the display to its nor-
not pressed, the display
When the beep function is turned on,
the symbol is also displayed on the
LC display.

7.3 Flash Bracketing Series (FB)

A series of flash exposures (flash-bracketing FB) can be carried out in the
and automatic A flash modes. A flash bracketing series consists of
three successive flash shots with different flash exposure correction values.
When a flash bracketing series is set, FB and the correction value appear on the
display. The possible correction values range from 1/3 to 3 apertures in one-
third aperture increments.
Setting procedure:
• Press the button repeatedly until „Select"
Sel
appears on the display.
• Select the menu option „FB" by pressing the
buttons. The selected menu option will be high-
lighted.
• Confirm the selection of the special function by pres-
sing the button.
Set
• Select the desired setting with the
tons. The setting takes effect immediately.
• Press the button repeatedly until the screen is
reset to its normal view. If the button
pressed, the display is automatically reset to its
normal view after about 5 seconds.
TTL
Remote
Select
FB
Standby
Set
and
FB
1
1 /
and but-
3
Set
is not
123