Remote Control Batteries Installation - Sanyo PLC SE10 Bedienungsanleitung

ZOOM BUTTON
Used to adjust zoom.
(P20)
FOCUS BUTTON
Used to adjust focus.
(P20)
MUTE BUTTON
Used to mute sound.(P21)
KEYSTONE BUTTON
Used to correct
keystone distortion.
(P20, 35)
NO SHOW BUTTON
Used to turn the picture
into black image. (P21)
AUTO PC ADJ. BUTTON
Used to operate AUTO PC
Adjustment function. (P24)
Remove the battery
1
compartment lid.
Press the lid down-
ward and slide it.
To insure safe operation, please observe the following precautions :
G Use (2) AA, UM3 or R06 type alkaline batteries.
G Replace two batteries at the same time.
G Do not use a new battery with an used battery.
G Avoid contact with water or liquid.
G Do not expose Remote Control Unit to moisture, or heat.
G Do not drop Remote Control Unit.
G If a battery has leaked on Remote Control Unit, carefully wipe the case clean and load new batteries.
G Danger of explosion if battery is incorrectly replaced.
G Dispose of used batteries according to battery manufacturer's instructions and local rules.
ON-OFF
ZOOM FOCUS VOLUME
Used to adjust volume.
(P21)
D.ZOOM
MUTE INPUT
D.ZOOM BUTTON
Used to select DIGITAL
ZOOM +/– mode and
MENU
resize image. (P29)
KEYSTONE
FREEZE BUTTON
Used to freeze the picture.
(P21)
NO SHOW FREEZE
AUTO PC ADJ. IMAGE
Used to select image
level. (P27, 32)
P-TIMER

Remote Control Batteries Installation

Slide the batteries into
2
the compartment.
Operating Range
Point Remote Control Unit toward
projector
whenever pressing any button.
VOLUME BUTTON
Maximum operating range for
Remote Control Unit is about 16.4'
(5m) and 60° in front and rear of the
projector.
IMAGE BUTTON
Two AA size batteries
For correct polarity (+
and –), be sure the
battery terminals are in
contact with the pins in
the compartment.
BEFORE OPERATION
(Receiver Window)
16.4'
(5 m)
60°
60°
16.4'
(5 m)
Replace the compartment
3
lid.
15