Inserting The Batteries - Silvercrest SWED 100 A1 - IAN 62912 Bedienungsanleitung

SilverCrest SWED 100 A1

Inserting the batteries

Remove the connection cable of the mains adapter if such a cable is
connected. Open the battery compartment (21) at the back of the device
by sliding the battery compartment cover downwards and removing it.
Insert the batteries with the correct polarity (note + and -) as shown in the
following illustration. The polarity is illustrated on the batteries and in the
battery compartment. Make sure that the ribbon (arrow) runs completely
under the batteries when you have inserted them. This makes it easier to
remove the batteries the next time it is necessary. Now insert the two
plastic tabs of the battery compartment cover into the slots provided for
this purpose at the lower end of the battery compartment (21) and then
slide the battery compartment cover upwards until it snaps into place.
English - 77