Silvercrest SWDR 500 A1 - IAN 273518 Bedienungsanleitung Seite 78

SilverCrest SWDR 500 A1
After you have set the alarm time you want, you can enable the alarm as
follows:
 While the device is powered off, press the "M-/AL1" button (14) briefly to
show the set alarm time on the display (6).
 Press the "M-/AL1" button (14) briefly once again to enable the alarm with
the buzzer. The corresponding icon (33) will appear on the display (6).
 Press the "M-/AL1" button (14) briefly once again to enable the alarm with
the radio. The corresponding icon (34) will appear on the display (6).
Please note that no earphones must be connected when waking up
with the radio. If the earphones are connected, the alarm sound
(buzzer or radio) is output over the earphones only.
 The device will power on at the set alarm time and will receive the last tuned-
in frequency and frequency band. However, if you have chosen the buzzer
during alarm setting you will wake-up with the buzzer.
 Press any button to cancel the alarm sound or press the "SNOOZE/BASS"
button (2) briefly to delay the alarm for approx. 5 minutes. The alarm
indicator (33, 34) flashes. After the 5 minutes snooze period, the alarm starts
again. If you press any button within the 5 minutes of snooze time, the
"SNOOZE" function is disabled but the alarm remains enabled.
Upon factory delivery the snooze delay is set to 5 minutes. If
required, you can customise it to up to 120 minutes. To do so, while
the device is powered off, keep the "SNOOZE/BASS" button (2)
pressed for approx. one second. The set snooze time is shown on
the display (6). Press the "VOL-" (12) or "VOL+" (4) buttons to
change the snooze time. You can keep the buttons pressed to
accelerate the digits count. Press the "SNOOZE/BASS" button (2)
briefly to apply the setting.
76 - English