Package Contents; Description (Fig. A); Electrical Safety - DeWalt dc 011 Anleitung

E N G L I S H
Additional safety instructions for battery packs
Fire hazard! Avoid metal short circuiting
the contacts of a detached battery pack.
Do not store or carry the battery pack
without the battery cap placed over the
contacts.
• The battery fluid, a 25-30% solution of potassium
hydroxide, can be harmful. In case of skin contact,
flush immediately with water. Neutralize with a
mild acid such as lemon juice or vinegar. In case
of eye contact, rinse abundantly with clean water
for at least 10 minutes. Consult a physician.
• Never attempt to open a battery pack for any
reason.
Labels on charger and battery pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
100%
Battery charging
100%
Battery charged
Battery defective
Do not probe with conductive objects
Do not charge damaged battery packs
Read instruction manual before use
Use only with D
others may burst, causing personal injury
and damage
Do not expose to water
Have defective cords replaced
immediately
20
WALT battery packs,
E
+40 ˚c
+4 ˚c
Charge only between 4 °C and 40 °C
Discard the battery pack with due care
for the environment
Do not incinerate the battery pack

Package contents

The package contains:
1 Radio/charger
2 Batteries
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.

Description (fig. A)

Your DC011 radio/charger has been designed for
playing radio transmissions at construction sites,
as well as for charging applications.
For radio transmissions, working on mains (corded)
or battery (cordless) power the tool can be used
both indoor and outdoor.
For charging applications, the tool accepts D
NiCd and NiMH battery packs ranging from
7.2 to 18 V.
1 Volume control
2 Mode selector
3 Station selector
4 Latch
5 Display
6 Charging indicator (red)

Electrical safety

Make sure that the voltage of your charger
corresponds to that of your mains.
Your D WALT charger is double
E
insulated in accordance with EN 60335;
therefore no earth wire is required.
WALT
E