Tone Control - Sangean RCR1 Bedienungsanleitung

Automatic station memory programming ( ATS )
When using the radio for the first time, the ATS function starts
automatically and stores in total 21 strongest stations in Preset
button 1-7 ( 7 each on MW/FM/LW bands ).
If you wish to repeat this process, turn on the radio, select required
band by pressing band selection knob 20 and press ATS button 16
for more than 4 seconds to execute the ATS function.
Storing the preset stations
Tune into the stations.
Select a memory preset button and press for more than 2 seconds
until a confirmed beep sounds and display M stops blinking.
The station is now stored.
Note:
When you store a new station in a memory slot, the station previously
in that slot is automatically erased.
Recall the station memories
Recall the station memories, simply select the required bands and
press required station memory slot buttons 1-7.
Volume
You can select the required volume by adjusting the Volume control
button 5.

Tone control

You can select the favorite tone by adjusting the Tone Control button
7.
GB
10