Setting The Correct Time; Listening To The Radio - Roadstar CLR-2855 Bedienungsanleitung

Note: If power is interrupted the time and alarm settings will be lost. When
power is restored the clock will begin indicating 00:00 that the time
and alarm settings must be corrected.

SETTING THE CORRECT TIME

1. Press shortly the CLOCK Button (10).
2. Press the TUN/TIME+ (3) or - (4) button to advance hour
3. Press shortly the CLOCK Button (10) again.
4. Press the TUN/TIME+ (3) or - (4) button to advance MINUTE until the
correct time is displayed.
5. Press shortly the CLOCK Button (7) to complete the setting operation.
SETTING THE WAKE UP TIME
1. Set the alarm time by following this procedure:
2. Press shortly the ALARM Button (6) two times.
3. Press the TUN/TIME+ (3) or - (4) button to advance hour
4. Press shortly the ALARM Button (6) again.
5. Press the TUN/TIME+ (3) or - (4) button to advance MINUTE until the
correct time is displayed.
6. Press shortly the ALARM Button (6) again.
Press the TUN/TIME+ (3) or - (4) button to select the alarm mode 1
7.
(BUZZER) or2 (RADIO)
8. Press shortly the ALARM Button (6) to finish.
9. Set the ALARM ON/OFF Selector (2) to the activate or deactivate the
English 3 4
10. To switch off the alarm set the ALARM ON/OFF Selector (2) to the OFF
9.

LISTENING TO THE RADIO

1.
2.
3.
4.
5. To listen the desired Radio stations, short pressSNOOZE button to select
6.
Note: For FM reception there is a built-in FM antenna wire at the rear of
the unit. Move the wire around to obtain the best reception.
English
alarm (when ON, the "" indicator will light up on the right side of the
display).
position.
Adjust the VOLUME (11) knob for the best Buzzer or Radio level.
Press shortly the ON/OFF/AUTO (7) button to switch the Radio ON .
Press shortly the ON/OFF/AUTO button again to start the Radio auto-
tuning function (the unit will store automatically the strongest stations).
Adjust the VOLUME Control (15) to a comfortable listening level.
To turn off the radio, keep pressed the CLOCK (10) button for three
seconds.
the stored station.
To search manually a Radio station, when in RADIO mode press the
TUN- (3) or TUNE UP (4) button sequentially until the desired frequency
is displayed, then press the SNOOZE button (1) to store in the memory.