Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Rear Panel Description
1.
LCD: Displays
Bluetooth, FM radio, USB and Aux.
Note: The LCD comes with a plastic protector on it.
Remove this for optimal viewing of the LCD.
2.
USB Port: Connect your USB flash drive to play
music.
3.
SD Card Slot: Insert your SD card here.
4.
Media Panel: Controls for the Bluetooth, SD, USB,
and FM radio sources. The Media Panel Mode
source symbol will illuminate when that source is
playing.
5.
Mic Input (1/4" and XLR): Connect a dynamic
microphone to the 1/4" or XLR inputs. Control the
volume of the XLR and 1/4" inputs using the Mic
Input volume knob.
6.
Aux Input: Connect a CD player, digital media
player, or other audio source to this 1/8" stereo
auxiliary input. Control the output volume using the
Line Input volume knob.
7.
Line Input (XLR): Connect a line-level mixer or
musical instrument to this XLR line-level input.
Control the output volume using the Line Input volume knob. Use this line-level
input when linking together two TOTAL PA units.
8.
RCA Inputs: Connect a CD player, digital media player, mixer, or other media
source to these inputs. Control the output volume using the Line Input volume knob.
9.
Mix Out: Connect this XLR output to another active (powered) speaker. The level of
the output is controlled by each channel's volume setting (Mic Input volume, Line
Input volume, and Media Panel volume).
10.
High EQ: Increases or decreases the high (treble) frequencies for Mic Input, Line
Input, and Media Panel sources at a range between -12dB to + 12dB.
11.
Low EQ: Increases or decreases the low (bass) frequencies for Mic Input, Line
Input, and Media Panel sources at a range between -12dB to + 12dB.
12.
Power LED: Indicates whether Total PA is powered on or off.
13.
Clip LED: This LED will flash red if the signal from the inputs or Media Panel source is clipping. If this
happens, decrease the setting of the Mic Input volume knob, Line Level volume knob, or Media Panel
volume knob.
14.
Media Panel Volume: Adjusts the speaker volume for the FM radio, SD card, USB port, and Bluetooth
sources.
15.
Power ON/OFF Switch: Turns Total PA on or off.
16.
Power Cable Input (IEC): Insert the included power cable here to power the unit.
the
Media
Panel modes
for
3
5
5
1
2
4
6
8
7
12
12
9
ON
16
16
Bluetooth Pairing
Instructions
10
10
11
11
13
13
14
14
15
15
OFF
POWER
Werbung
Inhaltsverzeichnis
Fehlerbehebung
