Yamaha NS-F901 Bedienungsanleitung Seite 5

Spike x 4
Note
The grille is detached from the speaker and packed
separately.
Be careful not to lose it.
Attaching the spikes
At the time of shipment, legs are attached to the speaker. When you use the supplied spikes, please remove the legs
first.
If you are setting up the speaker on a thick carpet, you can replace the legs with the spikes to increase stability and
improve sound quality. Remove the legs by turning them, then follow the steps below:
Spike nut
SUPPLIED ACCESSORY
Nut x 4
1 Lay the speaker on the floor.
Use a blanket or cushion to avoid scratches.
Spike
2
S crew each spike into a spike nut so that the nut will stay near
the tip of the spike.
3
R emove the legs and screw the spikes into the holes on the
bottom of the speaker.
4 P lace the speaker in the desired location in an upright position.
If necessary, adjust the length of the spike to match the depth
of the carpet by repeating the above-mentioned steps.
5 W hen the length adjustment is complete, firmly tighten the
spike nut to the base on the bottom of the speaker.
Notes
• Be sure to have another person support it.
• The tips of the spikes may scratch or damage the flooring.
Please be careful when positioning the speakers.
• The tips of the spikes are sharp. When you adjust the
protruding length of the spikes, be careful not to injure
your fingers.
The legs feature an adjustment function that enables you to
fine-tune the speaker height. If the speaker rattles on the floor,
adjust the length of the legs by turning them. Do not loosen the
legs too much. Otherwise, they may come off.
Loosen
(higher)
Leg
Tighten
(lower)
2
En