Cleaning The Housing; Cleaning, Troubleshooting - JGC LSR-4030 Bedienungsanleitung

Cleaning the housing

• Note for mains operation: Pull the plug out of the wall outlet before
every cleaning.
• Remove dust with a soft dusting cloth.
• Do not use a wet sponge, wax, spray polishes, or abrasives.
• Caution: Water must not penetrate the interior of the housing. If it does,
unplug the device from the mains (when using the power cord), and let
it dry out thoroughly before bringing it back into operation. Please do not
dry the device in an oven or microwave oven.
Troubleshooting
If an error occurs, check the table below first, before you contact your dealer
or send in the device. The address and hotline number can be found on the
warranty card. Do not open the device and do not try to repair it yourself.
You will lose the warranty claim and it is dangerous! Refer to the warranty
conditions on the following pages.
Possible cause
Problem: No sound.
The volume is set too low.
No batteries in the battery
compartment.
Note for mains operation: The plug
is not plugged in correctly.
Problem: Disturbances when playing radio.
The station is not properly tuned.
Telescopic antenna is not pulled out.
LSR-4030-IM-DE-EN-V1.indb 27

CLEANING, TROUBLESHOOTING

Solution
Set the volume higher.
Insert 6 batteries of the type AA/
UM-3.
Plug in.
Tune the station again.
Pull the antenna fully out.
27
09/03/2010 11:17