Cleaning Hard Floors; Important Tips - Thomas prestige 20 s AQUAFILTER Gebrauchsanweisung

M Place the cleaning fluid hose of the carpet
spraying nozzle onto the cut-off valve and lock
it in place by turning it. Press the cleaning fluid
hose into the hose receptacle on the suction
tubes, or in the case of stainless steel tubes, fasten
it to the tube with the smaller tube clips (39).
Connect the mains cable.
K Switch on the appliance with the On/Off (6)
switch.
Switch on the pump switch (7).
M Press the hook on the cut-off valve (16).
Cleaning fluid spray will begin.
Before refilling the cleaning fluid tank,
always empty the dirty water from the
collecting bin.

Cleaning hard floors

N
Assemble hard floor adapter.
See "Carpet cleaning" procedure.
We recommend THOMAS ProFloor cleaning
concentrate for cleaning hard floors.
Cleaning upholstery (according to model)
For cleaning your upholstery or car seats, please use
the upholstery spray extraction nozzle (23).
Take care not to apply too much liquid;
depending on the upholstery sublayer, you may
experience significant drying times.
O
Assemble the upholstery spray extraction nozzle.
Fasten the cleaning fluid hose by turning it. Fit the
nozzle onto the handle.
14
Cleaning and care of the spray extraction
system
H To care for the pump and valves
properly, fill the cleaning fluid tank
with clear water and insert it.
Connect the mains cable. Switch on the
On/Off switch (6) as well as the pump
switch (7).
M Operate the spraying system, e.g. over
a sink (disengage the hook on the cut-
off valve (16)).
K
Before removing the cleaning fluid hose, engage
the hook on the cut-off valve (16, figure M) in
order to release the remaining pressure in the
system, and then press the key on the quick
coupling (5).
Remove mains cable!
Afterwards, clean and dry the appliance and the
accessories you have used.
Never immerse the motor block in water!
Clean the motor block casing with a damp cloth and
wipe dry.

Important tips

When wet vacuuming, always vacuum by
drawing the carpet spray nozzle in straight
parallel strokes across the surface towards you.
In order to avoid soiling the carpet again, you
should not walk on shampooed carpets until they
have dried.
In order to achieve quicker drying of shampooed
surfaces, it is helpful to remove residual liquid
remaining in the carpet by vacuuming it again
– without engaging the valve hook.
When cleaning parquet floors, please observe
the instructions of the parquet floor manufacturer.