Manual Preset; Tuning Into A Preset Station - JVC KD-SH77R Bedienungsanleitung

Manual preset

You can preset up to 6 stations in each band
(FM1, FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the band (FM1–3, AM) you
want to store stations into (in this
example, FM1).
FM 1
2
Tune into a station of 88.3 MHz.
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
10
1 Press SOURCE
repeatedly to select FM
or AM as the source.
2 If necessary, to select
the FM band number,
press and hold M/B
(mode/band) for more
than 1 second
repeatedly. Each time
you press and hold the
button, the FM band
changes as follows:
FM 2 FM 3
Press ¢
to tune
into stations of higher
frequencies.
4 to tune
Press
into stations of lower
frequencies.
"P1" flashes for a while.
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset the
stations again.

Tuning into a preset station

You can easily tune into a preset station.
Remember that you must store stations first. If
you have not stored them yet, see "Storing
stations in memory" on page 9.
1
Select the FM or AM.
1 Press SOURCE
2 If necessary, to select
FM 1
2
Select the number (1 – 6) for the preset
station you want.
If the sound quality decreases and the
stereo effect is lost while listening to
an FM station
In some areas, adjacent stations may interfere
with each other. If this interference occurs,
this unit can automatically reduce this
interference noise (the initial setting when
shipped from the factory). However, in this
case, the sound quality will be degraded and
the stereo effect will be also lost.
If you do not want to degrade the sound
quality and to lose the stereo effect, rather
than to eliminate the interference noise, see
"To change the FM tuner selectivity – IF
FILTER" on page 26.
repeatedly to select FM or
AM as the source.
the FM band number,
press and hold M/B
(mode/band) for more
than 1 second
repeatedly. Each time
you press and hold the
button, the FM band
changes as follows:
FM 2 FM 3