Blowing Function; Interrupting Operation; Maintenance And Care; Troubleshooting - Kärcher WD 5.2series M Originalbetriebsanleitung


Illustration
Switch the appliance on (move the rotary
switch to the left to position
and start working.
Note: The suction turbine starts with a de-
lay of 0.5 seconds after the electric tool
has been switched on. After the electric
tool has been switched off, the suction tur-
bine will continue to run for approx. 5 sec-
onds to suck in the remaining dirt from the
suction hose.
Efficient filter cleaning
If the filter cleaning indicator is red, initiate the
filter cleaning.

Illustration
Insert the suction hose with the handle
into the accessory compartment on the
appliance head. Press the efficient filter
cleaning key 3 x times with the appliance
switched on; wait 4 seconds between the
individual presses.
Note: If the filter cleaning display is illumi-
nated permanently or after the filter clean-
ing switch has been activated several
times, check the reservoir for its fill vol-
ume. Otherwise, the dirt might escape
when the container is opened.

Blowing function

Cleaning hard to reach locations or, where
vacuuming is not possible, like leaves from a
gravel bed.

Illustration
Connect the suction hose to the blower con-
nection, this will activate the blower function.

Interrupting operation


Turn off the appliance.

Illustration
Hook the floor nozzle into the parking po-
sition.
Finish operation

Turn off the appliance and disconnect the
mains plug.
Empty the container

Illustration
Remove the appliance head and empty
the reservoir filled with wet or dry dirt.
For appliances with drain screw: Empty
the dry dirt over the container. Use the
drain screw to empty liquids.
MAX)
Storing the appliance

Illustration
Stow away the mains cable and accesso-
ry at the machine. Store the appliance in a
dry room.
Danger
Turn off the appliance and remove the mains
plug prior to any care and maintenance work.
Repair works may only be performed by the
authorized customer service.
Caution
Do not use abrasives, glass or universal clean-
ers! Never immerse the appliance in water.

Clean the appliance and accessory parts
made of plastic with a commercial plastic
cleaner.

If required, rinse the container and acces-
sories with water properly and dry them
before reuse.

Illustration
Only clean the cartridge filter under run-
ning water; do not wipe or brush. Let it dry
completely prior to installation.
Mains cable retraction does not function

The mains cable is probably dirty, clean
the mains cable.
If the cleaning power of the appliance deterio-
rates please check the following:

Accessories, suction hose or suction
tubes are clogged, please remove the ob-
struction using a stick.

Cartridge filter is dirty:
For appliances without efficient filter
cleaning: Knock the dirt off the cartridge
filter, clean it under running water if nec-
essary.
(see description / illustration
– 5
EN

Maintenance and care

Troubleshooting

Decreasing cleaning power
)
17