Operation; Maintenance - Wolf Garten Campus 1000 V Betriebsanleitung

Operation

Operating times
z Please check noise abatement regulations prevailing in your
country.
Feed cable through the strain relief
z Please feed cable through the strain relief.
Connecting to the mains (230 Volts, A.C., 50 Hz)
z The mower operates from any normal household mains sup-
ply, provided with a 16 Amps. fuse.
3
Note: Residual current protection device
These protection devices safeguard while touching
damaged wires, from insulation flaws and in certain cases,
also while damaging live wires.
z We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of not
more than 30 mA.
z Retrofit kits are available for old installations. Consult an elec-
trician.
Setting the working depth
1
Make sure the motor is switched off and the cutting bla-
des are not moving.
1. Pull the lever out.
2. Set the desired working depth.
3. Press the lever back in.

Maintenance

General
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
z pull out the power plug.
z Do not touch running blades.
G
E
F
Recommended working depths
Starting up the engine
1. Depress button (1) and hold.
2. Lift up bar (2) and release button (1).
Switch-off motor: Release bar (2).
1
Important:
Place the cable fi rmly off the lawn or on the already cut side of
the lawn when starting to mow.
Attach grassbox
H
Lift protective flap, hook grassbox with the hooks provided into the
holes in the chassis (see arrow), reattach protective flap.
Cleaning
z
Clean the unit thoroughly with a brush after each use.
z Do not spray with water.
z Store unit in a dry room.
3
We recommend
Allow a WOLF-Garten-service centre to check the unit in the au-
tumn.
Transport
10 mm
uneven lawn surface
- 4 mm
3
Note concerning blade
wear:
If the blades are visibly
worn down, two additio-
nal working depths can
be used.
1
Do not overload appli-
ance (reduce working
height if motor blocks)
G
11