Adjusting The Wheel Lock - Otto M1 Intro Bedienungsanleitung

6.5 Adjusting the Wheel Lock (Fig� 46/47)
To change the position of the rear wheels, first loosen the attachment screws of the clamp adapt-
ers of the wheel lock and push the wheel lock forward (Fig. 46). Then reposition the rear wheels.
The wheel lock should then be remounted such that the distance between the tyres and brake
block is max. 4 mm when the wheel lock is not activated (Fig. 47; subject to technical changes).
CAUTION
The wheel locks are only effective with sufficient air pressure and proper adjustment. The proper air
pressure is indicated on the side wall of the tyre, but should at least be 3�5 bar. To ensure sufficient
braking effect, use only original rear wheels with an approved radial excursion of maximally ± 1 mm.
INfORMATION
Make sure to firmly retighten all screws and nuts after making adjustments!
INfORMATION
Alternatingly tighten the screws of the clamp adapter with a torque of 14 Nm.
46 47
67