Exploded View Of The Housing; Connection Of Additional Indoor Sensors (Wgths) - Elsner WS1000 Installation Und Betriebsanleitung

Exploded view of the housing

Connection of additional indoor sensors (WGTHs)

Up to two separate additional indoor sensors for measuring temperature and
humidity can be connected to the control unit. Also, take care that no direct
draughts from windows or doors falsify the measurements.
128
Then push the cover a little way to the right
and lift off.
Before plastering the embeddable housing
in, you must remove the circuit board and
keep it in a safe place clear of dirt.
After connecting all wires, screw the pre-
mounted control unit housing onto the
embeddable housing. To finish, fit the cover
in on the right-hand side and press down
on the left.