Mounting The Weather Station; Notes On Installation - Elsner WS1000 Installation Und Betriebsanleitung

Mounting the weather station

Close the housing by putting the cover back over the bottom part. The cover
must snap in on the left and right with a definite "click".
To remove it, the weather station can be simply pulled upwards out of the
mount, against the resistance of the fastening.

Notes on installation

Do not open the P03 weather station if water (rain) could get in: even a few
drops could damage the electronics inside.
When mounting, you must take care not to damage the temperature sensor
(small PCB on the bottom of the housing). Also, the wire connecting the PCB
with the rain sensor must not be pulled off or kinked at the terminal.
After installation, remove all transport protection stickers present.
It will take 60 seconds after applying the power before the wind measurement
will be output.
Make sure the cover and bottom part are
properly snapped together! This picture is
looking at the closed weather station from
underneath.
Push the housing from above into the
fastened mount. The bumps on the mount
must snap into the rails in the housing.
125