Troubleshooting - D-Link DAP-1360 Installationsanleitung

TROUBLESHOOTING

SETUP AND CONFIGURATION PROBLEMS
1. HOW DO I CONFIGURE MY DAP-1360 RANGE EXTENDER WITHOUT THE CD, OR
CHECK MY WIRELESS NETWORK NAME (SSID) AND WIRELESS ENCRYPTION KEY?
- Connect your PC to the extender using an Ethernet cable.
- Open a web browser and enter the address http://dlinkap or http://192.168.0.50
- The default username is 'Admin'. The default password is '' (leave the field blank).
- If you have changed the password and can not remember it, you will need to reset the ap to
set the password back to '' (leave the field blank).
2. HOW DO I RESET MY DAP-1360 AP TO FACTORY DEFAULT SETTINGS?
- Ensure the ap is powered on.
- Press and hold the reset button on the rear of the device for 5 seconds.
Note: Resetting the ap to factory default will erase the current configuration settings. To re-
configure your settings, log into the ap as outlined in question 1, then run the Setup Wizard.
3. HOW DO I ADD A NEW WIRELESS CLIENT OR PC IF I HAVE FORGOTTEN MY
WIRELESS NETWORK NAME (SSID) OR WIRELESS ENCRYPTION KEY?
- Every PC that needs to connect to the ap wirelessly, you will need to ensure you use the
correct Wireless Network Name (SSID) and encryption key.
- Use the web based user interface (as described in question 1 above) to check or choose your
wireless settings.
- Make sure you write down these settings so that you can enter them into each wirelessly
connected PC. You will find a dedicated area on the back of this document, this important
information for future use.
TECHNICAL SUPPORT
DAP-1360
dlink.com/support
5