Operation; Operating Notes; Integration Into An Existing Electricity Grid; Devices Are Connected To The Ac Terminals - Zipper ZI-STE2800 Originalbetriebsanleitung

15

OPERATION

15.1

Operating Notes

15.1.1 Integration into an existing electricity grid

This power unit is designed exclusively for operating electric devices whose max. Performance
within the performance specifications of the generator. A higher starting current of inductive
loads must be considered.
The generator is designed to operate from conventional resistive and inductive loads, such as
Lights, electric hand tools (drills, electric chain saws, compressors) determined.
When connected to stationary systems such as heating, electrical supply, air condition-
ing systems or for the power supply of mobile homes, is regarding the connection and
the ground to draw necessarily a qualified electrician and the heater manufacturer for
advice.
Failure to comply with the provisions of the general regulations and the provisions of this manual,
the manufacturer for damages can not be held responsible.
By the manufacturer, the protection measure ˝ protective separation is provided with equipoten-
tial ˝ and installed.

15.1.2 Devices are connected to the AC terminals

 Before connecting a device on the AC socket you must control the perfect condition of the de-
vice.
 When you recognise that a connected device acts unusual you must stop the generator and
disconnect the device. Control whether the device is damaged or if the generator was over-
challenged by the device.
ATTENTION: A short exceed of the normed power capacity of the generator is possible but if this
happens oftener the life time of the generator will be shortened.
Standard performance overall ceiling:
Max total capacity:
Standard AC power per port with
Max capacity per AC connector with
In exceptions the generator can be charged with the maximum power for max. 30 minutes.
The following list gives you a view about the differences of the electricity requirement of some
devices between start and continuous operation.
Consumption Expenditure
type of watt
Start
Electrical equip- X1
ment
Z.I.P.P.E.R MASCHINEN GmbH  www.Zipper-maschinen.at
Stromerzeuger / Generator ZI-STE2800
Instance type of de-
vice
During
opera-
tion
X1
ZI-STE8000 / 8004 ZI-STE11000
2500 VA
800 VA
230V: 830 VA
230V: 930 VA
Instance
device
OPERATION
Start During
operation
100VA 100VA
Seite 36