Assembly; Delivery Content; Workplace - Holzmann KAM 50M Betriebsanleitung

13

ASSEMBLY

The KAM 50M is a mobile edge banding machine for banding of hot melt adhesive-coated edges of
veneer, plastic and similar materials on straight and round workpieces.
The finishing of the adhered edge is done with the double edge trimmer and the end trimmer.
Note the maximum banding width is depending of the edge thickness
13.1

Delivery content

Check the delivery content:
 Edge banding machine KAM 50M
 Double edge trimmer
 End trimmer
 User manual
13.2

Workplace

 Well ventilated
 No any flammable materials
 Grounded power supply 220V/50Hz
When working with non-grounded machines:
Severe injury or even death may arise though electrocution!
Therefore: The machine must be operated at a grounded power socket
The connection of the machine to the electric power supply and the following checks have to be
carried out by a respectively trained electrician only.
1. The electronic connection of the machine is designated for operation with a grounded
power socket!
2. The connector plug may not be manipulated.
3. he mains supply must be secured with 16A:
4. If the connector plug doesn't fit or if it is defect, only qualified electricians may modify or
re-new it!
5. The grounding wire should be held in green-yellow.
6. A damaged cable has to be exchanged immediately!
7. Check, whether the feeding voltage and the Hz comply to the required values of the ma-
chine. A deviation of feeding voltage of ±5% is allowed (e.g.: a machine with working
voltage of 380V can work within a voltage bandwidth of 370 till 400V.
8. Make sure that a possible extension cord is in good condition and suitable for the
transmission of power. An undersized cord reduces the transmission of power and heats
up.
9. A damaged cable must be replaced immediately
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
A T T E N T I O N
MOBILES KANTENANLEIMGERÄT / EDGE BANDING MACHINE
ASSEMBLY
Seite 23
KAM 50M