Operating The Xtr4; Selecting An Area Of Stimulation - schwa-medico SPORÉCUP XTR4 Gebrauchsanweisung

Connecting the Cables
and the electrodes
Switching On the XTR4
Selecting a Program
a
Selecting an area
of Stimulation
Starting the Stimulation
OPeRaTInG ManUaL SPORÉCUP XTR4

Operating the XTR4

Connect the electrodes with the cable(s) (always 2 electrodes per
cable). Connect the cables to the XTR4 on sockets no. 6. Place the
electrodes on the desired area (see electrode placement).
Switch the commutator (no. 8) to the ON position. Press the 8 key to
start the device. The program shown on the display is the last program
used. The device automatically switches off after 2 minutes of disuse.
If the display shows a key symbol on the upper left side, the XTR4 has
previously locked a specific program (see chapter locking the key pad).
Ensure that the XTR4 has not been locked on one program. Select
a program by pressing the P key. To scroll through the programs,
press the P key as often as necessary until you have selected the
program of your choice. To return to the previous program, press one
6
of the keys.
Press the E key to select the area of stimulation before starting the
stimulation. Depending on the selected program you can choose
between upper and lower limbs. The body symbol on the display is
half colored in black, depending on the selected limbs.
Programs with a possibility of upper and lower limbs stimulation:
P1, P5, P6, P7, P9, P10, P15, P16, P17, P18, P19, P20, P21, P22, P23, P24,
P25, P26, P27, P28, P29
First check if you have selected the right program and if cables and
electrodes are well connected and well positioned on the skin. Start
the stimulation by increasing the intensity with the
channel(s) connected to the electrodes.
37
5
key of the