Herunterladen Inhalt Inhalt Diese Seite drucken

Frost Precautions; Troubleshooting - Electrolux WTSL4E201 Benutzerinformation

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

32
www.electrolux.com
13.8 Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (9) of
'Cleaning the drain filter'. If necessary,
clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2. Start the programme to drain the
water.

13.9 Frost precautions

If the appliance is installed in an area
where the temperature can be less than

14. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
14.1 Introduction
The appliance does not start or it stops
during operation.
First try to find a solution to the problem
(refer to the table). If the problem persists,
contact the Authorised Service Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
- The appliance does not fill with
water properly.
- The appliance does not drain
the water.
14.2 Possible failures
Problem
The programme does
not start.
0° C, remove the remaining water from the
inlet hose and the drain pump.
1. Disconnect the mains plug from the
2. Close the water tap.
3. Put the two ends of the inlet hose in a
4. Empty the drain pump. Refer to the
5. When the drain pump is empty, install
Possible solution
Make sure that the mains plug is connected to the mains
socket.
Make sure that the appliance door is closed.
Make sure that there is not a damaged fuse in the fuse box.
mains socket.
container and let the water flow out of
the hose.
emergency drain procedure.
the inlet hose again.
WARNING!
Make sure that the
temperature is higher than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
- The appliance door is open or
not closed correctly. Please check the
door!
- The mains supply is unstable.
Wait until the mains supply is stable.
- No communication between
electronic elements of the appliance.
Switch off and switch on again.
- The anti-flood device is on.
Disconnect the appliance and close the
water tap. Contact the Authorised
Service Centre.
WARNING!
Deactivate the appliance
before you do the checks.

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis