Installation - IKEA RENLIG IWM60 Anleitung

ENGLISH
Spinning class
Washing noise (dB(A))
Spinning noise (db(A))
Average annual energy
consumption (kWh)
Average annual water con-
2)
sumption (litres)
1) If the pressure in your area is lower or higher, please contact your After Sales Service.
2) The data is based on the Standard Cotton programmes for test institutes assuming 220 cycles per a year.
Information on the electrical connection, voltage and overall power is given on the rat-
ing plate, on the inner edge of the appliance door.

Installation

Caution! Refer to the assembly
instructions, in order to proceed with
the installation.
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Place the appliance on the floor and install
it under a counter (kitchen worktop or sink).
If a repair is necessary, the appliance must
be easily accessible for the engineer. Put
the appliance adjacent to a water tap and
a drain.
For the venting of the appliance only water
fill, water drain and power supply cable
openings are necessary.
Water inlet
1
B
53
70
192
2)
8699
Connect the hose to
a tap with 3/4"
thread.
2
35° 45°
Caution! Do not place the inlet hose
downwards.
The inlet hose must not be lengthened.
If it is too short and you do not wish to
move the tap, you will have to purchase a
new, longer hose specially designed for this
type of use.
22
Turn the inlet hose
to the left or the
right to suit the in-
stallation. Tight the
locknut correctly to
prevent water
leaks.