Operating Procedures - Jacobsen 67945 – LF 3400, Kubota V1305-E, 5 Gang, 2WD Betriebshandbuch

4 OPERATION
4.3

OPERATING PROCEDURES_________________________________________________

A Rollover Protection Structure (ROPS) for this tractor is available as an optional accessory. Evaluate the terrain
and working conditions to determine if a ROPS is required. Seat belts must be worn whenever a ROPS is installed
on the tractor. Always keep seat belt snugly adjusted. DO NOT use seat belts on a tractor without a ROPS.
If a ROPS is installed and the tractor is overturning, hold onto the steering wheel. Do not attempt to jump out or
leave the seat.
To prevent injury, always wear safety glasses, leather work shoes or boots, a hard hat, and ear protection.
1. Under no circumstances should the engine be
started without the operator seated on the tractor.
2. Do not operate tractor or attachments with loose,
damaged or missing
possible mow when grass is dry.
3. First mow in a test area to become thoroughly
familiar with the operation of the tractor and control
levers.
Never operate the reels unless they are mowing
grass. Heat will develop between the bedknife and
reel and damage the cutting edge.
4. Study the area to determine the best and safest
operating procedure. Consider the height of the
grass, type of terrain, and condition of the surface.
Each condition will require certain adjustments or
precautions.
5. Never direct discharge
bystanders, nor allow anyone near the machine
while in operation.
responsible for injuries inflicted to bystanders and/or
damage to their property.
!
Before mowing, pick up all debris such as rocks, toys
and wire which can be thrown by the machine. Enter a
new area cautiously. Always operate at speeds that
allow you to have complete control of the mower.
6. Use discretion when mowing near gravel areas
(roadway, parking areas, cart paths, etc.). Stones
discharged from the implement may cause serious
injuries to bystanders
equipment.
7. Always turn reel switch off to stop blades when not
mowing.
GB-13
components. Whenever
of material
The owner/operator
CAUTION
and/or damage
!
WARNING
!
CAUTION
8. Disengage the drive motors and raise the reels
when crossing paths or roadways. Look out for
traffic.
9. Stop and inspect the equipment for damage
immediately after striking an obstruction or if the
machine begins to vibrate abnormally. Have the
equipment repaired before resuming operation.
Before
equipment, always disengage all drives, lower
implements to the ground, engage parking brake,
stop engine and remove key from ignition switch
to prevent injuries.
10. Slow down and use extra care on hillsides. Read
Section 4.10. Use caution when operating near drop
offs.
toward
11. Look behind and down before backing up to be sure
is
the path is clear. Use care when approaching blind
corners, shrubs, tress or other objects that may
obscure vision.
12. Never use your hands to clean cutting units. Use a
brush to remove grass clippings from blades.
Blades are extremely sharp and can cause serious
injuries.
the
!
WARNING
you clean, adjust, or repair this