Using The 3-In-1 Function; Loading The Dishwasher Baskets - Klarstein 10027045 Bedienungsanleitung

Please observe the manufacturer's dosing and storage recommendations as stated on the detergent
packaging. Close the lid and press until it locks in place. If the dishes are heavily soiled, place an
additional detergent dose in the pre-wash detergent Chamber. This detergent will take effect during
the pre-wash phase.
There are 3 sorts of detergents:
• With phosphate and with chlorine
• With phosphate and without chlorine
• Without phosphate and without chloride
Normally new pulverized detergent is without phosphate. The water softener function of phosphate
is not given. In this case we recommend to fi ll salt in the salt container even when the hardness of
water is only 6 dH. If detergents without phosphate were used in case of hard water often white
spots appear at dishes and glasses. In this case please add more detergent to reach better results.
Detergents without chlorine do only bleach a little. Strong and coloured spots will not removed
completely. In this case please choose a programme with higher temperature.
Use of 3-in-1 detergent tablets
ATTENTION
Before using these products you should fi rst check that the water hard-ness in your supply
is compatible with the use of these products as per the detergent manufacturers instruc-
tions (on the packaging). When using combination products, the rinse-aid and salt lights are
no longer useful. It may be helpful to select the lowest possible setting for water hardness.

Using the 3-in-1 function

• If you use 3-in-1 peoducts use the 3-in-1-function. in1washing cycle is additional function, they
must be used with other programme (Intensive, Eco and Light).
• To select 3-in-1 function press the power switch and select the 3-in-1 washing cycle by pressing
the option button 3-in-1 until the „3in1" indicator blinks.
• The 3-in-1 washing cycle will be available after pressing the Start/Pause button.
• If you decide to switch to the use of a standard detergent system we advise that you refi ll both the
salt and rinse aid compartments. Switch the water hardness setting to the highest possible position
and run for three normal cycles without load.
• Readjust the water hardness setting again according to the conditions for your region (For more
information please refer to your instruction manual).

Loading the Dishwasher Baskets

For best performance of the dishwasher, follow these loading guidelines. Features and appearance
of baskets and silverware baskets may vary from your model. Scrape off any large amounts of lefto-
ver food. It is not necessary to rinse the dishes under running water.
Place objects in the dishwasher in the following way:
• Items such as cups, glasses, pots/pans, etc. are stood upside down.
• Curve items, or those with recesses, should be at a slant so that water can run off.
• They are stacked securely and can not tip over.
• They do not prevent the spray arms from rotating while washing takes place.
• Very small items should not be washed in the dishwasher as they could easily fall out of the bas-
kets.
29