AL-KO Robolinho 100 Originalbetriebsanleitung Seite 28

en
1 Use the [arrow keys] (3-3) to select the requi-
red language.
2 Confirm with the [multifunction key] (3-5).
After confirming, the LCD display (3-1)
shows [Enter registration PIN].
PIN code
Entering the factory-set PIN code
The factory-set PIN code only needs to be entered
during the initial start-up. The factory-set PIN code
is [0000].
[ Registration ]
Enter PIN
****
1 Use the corresponding [arrow keys] (3-3) to
select the corresponding digits and confirm
each one with the [multifunction key] (3-6).
2 Enter the next 3 required digits in the same
way.
Following this, the LCD display (3-1)
shows the [Change PIN] dialogue box.
Changing the PIN code
1 Enter a new PIN and repeat.
After this, the LCD display (3-1) shows
the [Date dialogue box].
Setting or changing the date
Enter the date and time correctly, because further
programming depends on the date and time.
[ Enter the date
DD.MM.YYYY
13.06.2013
1 Use the corresponding [arrow keys] (3-3) to
select the corresponding digits and confirm
each one with the [multifunction key] (3-5).
After confirming, the LCD display (3-1)
shows [Time dialogue box].
28
Setting or changing the time
1
Calibration
For calibration, set up the Robolinho accordingly
(12-3)
1
]
Calibration procedure
The Robolinho first moves straight over the boun-
Confirm
dary cable in order to gauge the signal strength,
and then into the base station. The battery of the
Robolinho is charged.
When entering the year (YYYY), it is only
necessary to enter the last two digits be-
cause the first two 20XX are preset.
[ Enter time ]
24 hour format
7:00
Abort
Use the corresponding [arrow keys] (3-3) to
select the corresponding digits and confirm
each one with the [multifunction key] (3-5).
Following this, the LCD display (3-1)
shows the [Uncalibrated] status window.
13.06.2013
! Warning !
Drive starts
Charge 80%
The automatic calibration procedure starts
when the [START key] (3-4) is pressed.
The [Drive starting] warning flashes on
the LCD display (3-1).
CAUTION!
The drive starts when the [START key]
is pressed.
Do not reach into rotating parts.
Start-up
Confirm
12:15
Robolinho 100
©