Using The Power Box - Wolf Garten Ambition Robo Scooter 300 Betriebsanleitung

Near Wire Follow
P016
Test
6.5 Operation in a Non-Base Zone (using a Perimeter Switch)
In order for the unit to operate in a Non-Base Zone, the Perimeter Switch has to be turned on and the mower should be
inside the active perimeter area.
•
Verify that the Perimeter Switch is connected to the zone to be mowed.
•
Press the 'ON' button to turn on the Perimeter Switch.
•
Drive/carry the unit to the lawn area.
•
To initiate the operation, choose the operation mode you want, press the arrow buttons to choose the Zone you want to
mow and press OK to start operation (refer to Section 6.3).
•
When the unit completes the mowing, it wil stay on the lawn. You will have to drive/carry it back to its place for
charging.

7. Using The Power Box

7.1 Power Box Alerts
Event
Docking Indicator is lit.
Operating Indicator is lit
On/Off Button Indicator is lit.
'OFF' will be displayed on the
mower.
Wire Indicator -
Flashes and Beeps
All Indicators flash
All Indicators flash and Buzzer
sounds for 10 seconds.
Note - To stop an alert when sounding, press the On/Off Button.
7.2 Turn the Buzzer On/Off
• Press and hold the On/Off button for 10 seconds.
-
A short beep indicates On.
-
A flash indicates Off.
76
• Enables to test the mower in the max 'Near wire Follow Distance' that
is defined in menu P004.
• If the mower is not able to complete the drive in 'Near Wire' mode
smoothly, then it is recommended to reduce the max distance set in
menu P004.
Alert
The mower is in its Base Station.
The mower is not in its Base Station.
Mowing schedule is Off.
The Perimeter Wire is cut, disconnected,
or too long.
The mower did not return to the Base
Station after 4 hours of departure.
When the mower is detected at the Base
Station, alerts will turn Off.
The Anti-Theft option is set to On, and
the mower was removed from its Base
Station when it was not scheduled to
operate.
en