Abicor Binzel 350GC Betriebsanleitung Seite 25

®
ABIROB 350GC
6.1 Mounting the torch neck
1
5
1 Spigot nut
2 Torch neck 35° bent
Fig. 3 Mounting the torch neck
6.2 Mounting the wire guide
3 iBracket torch seat (module)
4 Cylindrical pin
1 Slide spigot nut (1) and protective cap (4) onto the torch neck (2) from the
front.
2 Slide torch neck (2) with positioning on cylindrical pin (3) in the torch seat
(2) .
3 Screw down torch neck (2) with spigot nut (1) .
4 Replace protective cap (4) .
For mounting the wire guide, there are several options available:
• Wire guide for torch neck and cable assembly are separate.
 6.2.1 Torch neck on page EN-10
 6.2.2 Cable assembly on page EN-11
• Wire guide continuous.
 6.2.3 Continuous on page EN-11
2
4
5
6 Putting into operation
3
Protective cap
EN - 9