Figure 5-13: Available Wireless Network; Figure 5-14: Network Settings - Linksys WUSB54GR Benutzerhandbuch

Wireless-G USB Network Adapter with RangeBooster
Manual Setup
If your network is not listed with the available networks, you can use Manual Setup.
1. Click Manual Setup on the Available Wireless Network screen to set up the adapter manually.
2. The Network Settings screen from the Wireless Network Monitor will appear. If your network has a router or
other DHCP server, click the radio button next to Obtain network settings automatically (DHCP).
If your network does not have a DHCP server, click the radio button next to Specify network settings. Enter
an IP Address, Subnet Mask, Default Gateway, and DNS addresses appropriate for your network. You must
specify the IP Address and Subnet Mask on this screen. If you are unsure about the Default Gateway and DNS
addresses, leave these fields empty.
IP Address - This IP Address must be unique to your network.
Subnet Mask - The Adapter's Subnet Mask must be the same as your wired network's Subnet Mask.
Default Gateway - Enter the IP address of your network's Gateway here.
DNS 1 and DNS 2 - Enter the DNS address of your wired Ethernet network here.
Click the Next button to continue, or click the Back button to return to the previous screen.
Chapter 5: Using the Wireless Network Monitor
Create a New Profile

Figure 5-13: Available Wireless Network

Figure 5-14: Network Settings

25